No.#4 Set timezone on nutanix running cluster Want to know nutanix cluster and running services status, Issue following command from any CVM cvm$ cluster status No.#3 Show cluster status and running services
Production To Start Nutanix cluster following commandĬvm$ cluster start To Stop Nutanix cluster following command Stop the nutanix cluster for sometime and start again to begin Use –redundancy_factor 3 need atleast 5 nodes for build the nutanixĬluster, RF-3 keeps two additional copy of master data, if two nodesįor any hardware maintenance or relocation of the nutanix nodes need to Goes down or in maintenance mode no impact on nutanix cluster Use –redundancy_factor 2 need at least 3 nodes for build the nutanixĬluster, RF-2 keeps one additional copy of master data, if one nodes Note: –redundancy_factor parameter has to values 2 and 3 OR can do same thing to add extra prefix parameters in above command cvm$> cluster –cluster_name= -cluster_external_ip= -dns_servers= -ntp_servers= -redundancy_factor=2 -s cvm1_IP_addr,cvm2_IP_addr,cvm3_IP_addr, So on.
Note: Each CVM IP adddress separeted by comma (,) without space Issue following commands of any controller VM (CVM) cvm$> cluster -s cvm1_ip_addr,cvm2_ip_addr,cvm3_ip_addr create Make sure that all the CVMs, Nodes and IPMI IP addresses are reachable or ping able to each other. If you are planning to create new Nutanix cluster required at least three nodes for RF-2 cluster PS As for Unix SE questions, when dealing with hardware questions, a full lscpi output is probably more useful.No.#1 Build a new Nutanix cluster with at least 3 nodes 8021q: adding VLAN 0 to HW filter on device eth0Īs for dmidecode, dmidecode -t baseboard might show information about NICs that are built-in in the motherboard. e1000: eth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: None Grepping dmesg for the network device might also help: $ dmesg | grep eth0
Product: 82545EM Gigabit Ethernet Controller (Copper)Ĭapabilities: pm pcix bus_master cap_list rom ethernet physical logical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiationĬonfiguration: autonegotiation=on broadcast=yes driver=e1000 driverversion=7.3.21-k8-NAPI duplex=full ip=192.168.5.143 latency=0 link=yes mingnt=255 multicast=yes port=twisted pair speed=1Gbit/s Or for getting more detail of the NIC(s): $ sudo lshw -class network For getting the brand/model of the network card, usually you run: $ lspci | grep -i EthernetĠ2:01.0 Ethernet controller: Intel Corporation 82545EM Gigabit Ethernet Controller (Copper) (rev 01)
0 kommentar(er)
